So, to start off. I’ve been slacking off a lot with stuff around the house. pushing off everything that should be done and needed to be done, with that being said, here starts my journey to home renovations.
When I first move into my house i decided to do some networking and install my router and modem into a little closet. it worked for a bit until my router broke. i bought another router and was just too lazy to re install it properly which it has been sitting for 1/2 year or more and to top that off it on top of my oil tank so reception is terrible
Just to clean things up a bit i printed a desk cable grommet from http://www.thingiverse.com/thing:171249 resized to about 1″ hole opening then drilled a hole for my cables
then now i just run all the cable to that hole and mount my router.
and the final results are pretty good
thanks for reading!!
View Comments (6)
555
555
if(now()=sysdate(),sleep(12),0)
pOaXYWqn' OR 117=(SELECT 117 FROM PG_SLEEP(12))--
555*DBMS_PIPE.RECEIVE_MESSAGE(CHR(99)||CHR(99)||CHR(99),12)
555